MMSC Debounce Setting
#1
MMSC Debounce Setting
How are command changes sent to the mmsc? I'm trying to increase the debounce rate for the buttons on the mmsc, I get 2-5 hits per press and I'd like to increase the debounce rate. I found this:

MMSC
-----
MMSC is connected to 2 or more MSC ports; MMSC only used with 2 or more
O2000 

MMSC display keypad debounce problem (FYI 100882 100884 100737) 
MMSC>r 1 MMSC>setenv DEBOUNCE_DELAY 200000

Do I have to connect to the mmsc through the 8-pin din?

 Onyx2 Rack Origin 2000 Deskside  Octane2
(This post was last modified: 02-12-2019, 04:18 AM by vladio.)
vladio
O2

Posts: 16
Threads: 5
Joined: Jan 2019
Find Reply
02-12-2019, 04:17 AM
#2
RE: MMSC Debounce Setting
Hi,

I had exactly the same problem.
The following did work perfectly for me:

1. Disconnect the DIN8/DB9 cable of the Graphics Rack

2. Connect the DIN8 on the TEST port of the MMSC (I tried with other ports but it wasn't successful -> to be understood)

3. Connect the DB9 on your computer/laptop

4. Set serial connection on Putty/MobaXTerm/HyperTerminal with these parameters:
- Baud rate: 9600
- Data bits: 8
- Stop bits: 1
- Flow control: Xon/Xoff

5. Press Ctrl+t
MMSC prompt should be displayed

6. Now you can enter the debounce delay command
MMSC>SETENV DEBOUNCE_DELAY 200000

Note:
I found a really nice and useful post here:
http://www.nevynsblog.co.uk/2008/10/sgio...-help.html

Regards
Noguri


Posts: 6
Threads: 1
Joined: Apr 2019
Find Reply
04-09-2019, 08:02 PM


Forum Jump:


Users browsing this thread: 1 Guest(s)