Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Do you leave your machines plugged in, when they're not in use?
#11
Re: Do you leave your machines plugged in, when they're not in use?
I leave all my shite plugged in.. mind you, my electricity bill is about £180 a month.. some stuff has to stay on 24/7..
Hey Ho Pip And Dandy!!!!!

Onyx2 :O2K_d-1: Origin 200 :tezro: Octane2 O2 Indigo Indy :320:
uunix Offline
Octane

Posts: 198
Threads: 26
Joined: Dec 2017
Find Reply
08-09-2018, 08:57 PM
#12
Re: Do you leave your machines plugged in, when they're not in use?
I leave my stuff plugged in too. If I plan on doing stuff with my SGI's I leave them up 24/7 too. If I find myself in an SGI lul and not really touching them I turn them off for a few months until I get back to them. I usually just leave my Tezro plugged in because its too much of a pain to get under my desk and unplug it.
gijoe77 Offline
Tezro

Posts: 361
Threads: 23
Joined: Jun 2018
Find Reply
08-10-2018, 12:05 AM
#13
Re: Do you leave your machines plugged in, when they're not in use?
We've had this question earlier on Nekochan forum.
You are working with computer equipment that is at least 15 years old. Some stuff is approaching 30 years. As JanJaap mentioned on Nekochan, leaving the stuff running unsupervised (AKA asleep) is a potential fire hazard.
Like JanJaap I have a wife and children sleeping in my house, so everything is shut off when not in use.
dexter1 Offline
Global Moderator
******

Posts: 133
Threads: 9
Joined: May 2018
Find Reply
08-10-2018, 04:03 AM
#14
Re: Do you leave your machines plugged in, when they're not in use?
JacquesT post_id=2134 time=1533839658 user_id=104 Wrote:
55cancri post_id=2133 time=1533837968 user_id=247 Wrote:My Octane2 (single CPU, Vpro) draws 13.2 Watts while being off. That is just too much for letting it plugged in all the time :-(

Hm, my single cpu vpro seems to draw more at 19W? That's a bit weird.

PS - My RAM comment was in relation to unplugging the fan of the PSU in an O2 to run it silent, not regarding power consumption. Unplugging a PSU fan from an O2 is bad just plain bad juju and asking for trouble!

Maybe it is because of the PSU or the configuration :

PM10400MHZ Board: part 030-1475-001 rev B
IP30 Board: part 030-1467-001 rev D
FP1 Board: part 030-0891-003 rev J
PWR.SPPLY.S2: part 060-0038-001 rev D
ODY32VERSIONB Board: part 030-1655-001 rev C

1 400 MHZ IP30 Processor
Main memory size: 2560 Mbytes
Xbow ASIC: Revision 1.4


sgidepot.co.uk says it is an earlier Lucent PSU at a later revision with improved design. Also there is only one harddisk (fujitsu MAX3073NC) in the octane2. In idle it takes 191 Watts.
55cancri Offline
O2

Posts: 17
Threads: 2
Joined: Jun 2018
Find Reply
08-10-2018, 06:00 AM
#15
Re: Do you leave your machines plugged in, when they're not in use?
dexter1 post_id=2161 time=1533873807 user_id=141 Wrote:We've had this question earlier on Nekochan forum.
You are working with computer equipment that is at least 15 years old. Some stuff is approaching 30 years. As JanJaap mentioned on Nekochan, leaving the stuff running unsupervised (AKA asleep) is a potential fire hazard.
Like JanJaap I have a wife and children sleeping in my house, so everything is shut off when not in use.

so you mean you actually physically unplug it or just power it down and leave it plugged in?
gijoe77 Offline
Tezro

Posts: 361
Threads: 23
Joined: Jun 2018
Find Reply
08-10-2018, 03:45 PM
#16
Re: Do you leave your machines plugged in, when they're not in use?
I physically unplug machines which are not in use. I do have an O2 which I use on a daily basis and that stays plugged in and I turn it on and off whenever I need it, except when I am on vacation or too busy to work on it, then I pull the plug. The room which contains the O2 also has a fire alarm.

Actually, you made me realize that I had not considered what could happen when I leave the O2 shut off but connected to the grid. I had problems turning on the O2 when left unconnected so I keep that system plugged in.
I also clean PSU's and refit new fans before using them, but I am dubious if I need to put the O2 on a switchable power block.
dexter1 Offline
Global Moderator
******

Posts: 133
Threads: 9
Joined: May 2018
Find Reply
08-10-2018, 06:21 PM
#17
Re: Do you leave your machines plugged in, when they're not in use?
I'm sort of recalling a post Ian made about a wireless power switch he used, he had a remote control to power it on and off - I'll might just have to maybe start thinking about that.
gijoe77 Offline
Tezro

Posts: 361
Threads: 23
Joined: Jun 2018
Find Reply
08-10-2018, 07:08 PM
#18
Re: Do you leave your machines plugged in, when they're not in use?
Irinikus post_id=2137 time=1533840925 user_id=62 Wrote:Do you guys make use of a true RMS power meters to get your power consumption values?

I measure the power consumption through this powermeter thing and I also bought an extra switch (under the powermeter) to shut my Octane completely off.


Attached Files Image(s)
   
55cancri Offline
O2

Posts: 17
Threads: 2
Joined: Jun 2018
Find Reply
08-11-2018, 05:25 PM
#19
Re: Do you leave your machines plugged in, when they're not in use?
55cancri post_id=2226 time=1534008301 user_id=247 Wrote:
Irinikus post_id=2137 time=1533840925 user_id=62 Wrote:Do you guys make use of a true RMS power meters to get your power consumption values?

I measure the power consumption through this powermeter thing and I also bought an extra switch (under the powermeter) to shut my Octane completely off.

That's a pretty cool piece of kit!
[Image: rZbyrYx.png]
Irinikus Offline
Tezro

Posts: 503
Threads: 65
Joined: Dec 2017
Discord: Irinikus
Find Reply
08-11-2018, 06:22 PM
#20
Re: Do you leave your machines plugged in, when they're not in use?
I have one of these to meter

   
gijoe77 Offline
Tezro

Posts: 361
Threads: 23
Joined: Jun 2018
Find Reply
08-12-2018, 10:26 AM


Forum Jump:


Users browsing this thread: 1 Guest(s)